Granite countertops add a touch of luxury and elegance to any kitchen. They're durable, resistant to heat and scratches, and offer a unique look that can't be matched by other countertop materials. However, despite their strength, granite countertops are not immune to chips. Chips can occur due to a variety of reasons, including accidental drops or impacts, cuts, and more. If you have a chip in your granite countertop, don't panic. With the right tools and materials, you can easily repair it yourself. In this guide, we'll show you how to repair chips in granite countertops, step-by-step.
Before you start repairing your granite countertop, you'll need to get a good granite repair kit with what you can fix your defect. Check our selection of repair kits here.
Step 1: Clean the Surface
Start by cleaning the surface of your granite countertop with warm water and soap. Make sure to remove any dirt, debris, or grease that may be on the surface. This will ensure a strong bond between the epoxy resin and granite.
Step 2: Apply Filling Material
Once the surface is clean, apply the filling material on your chip or defect
Step 3: Apply Leveling Tape
Apply leveling tape afer you have added the filling on the chip. If your chip is deeper than few mm then you need to repeat the curing process and cure in levels.
Step 4: Apply Blue Light
Once you have applied the leveling tape it's time to apply blue light on the surface. It's extremely important that you used the leveling tape as well. Shine the blue light on the surface for approx 20 seconds.
Step 5: Sand the Surface
Sand the surface using the grit paper that's in the package.
Step 6: Clean the Surface and Polish
Finally, polish the surface of the granite countertop and clean it with warm water. This will remove any residue from the polishing powder.
By following these six simple steps, you can repair chips in granite countertops easily and effectively. With the right tools and materials, you can restore the beauty and functionality of your granite countertop in no time. Remember to always be careful and take your time, as rushing through the process can lead to mistakes and additional damage.